FCB (FlexPay Control Board) Programming

The purpose of this article is to assist programming a FlexPay II FCB (FlexPay Control Board), part number GBM11930K001, GBM11930K001R, GBM11930K001FR, GBM11930K002R, or GBM11930K002RFR:

Step 1: Take a photo of the FCB serial number the 8-digit S/N displayed upon boot up.

Step 2: When unit displays <1> Enter Setup in bottom right-hand corner, press 1 then ENTER.

Step 3: Enter the last 6 of the FCB serial number

Step 4: Press 2 (SECURE SETUP MENU)

Step 5: Use the ASC APP to ENTER MATCHING PASSWORD

Step 6: Press 4 (PROTOCOL MENU)

Step 7: Press 1 (CRIND TLS Authentication) until the correct protocol is selected and press ENTER

                VeriFone Commander POS set to SINGLE AUTHENTICATION

                Gilbarco Passport POS set to MUATUAL AUTHENTICATION

Step 8: EXIT all the way out.

Step 9: Insert and remove the CRIND Diagnostic Card

Step 10: In the Main Menu Press 1 (CRIND Config) and press ENTER

Step 11: Press 1 (CRIND IDs)

Step 12: Press 1 (CRIND ID Side 1) and press ENTER

• Side A set to 7 and Side B set to 11 (Gilbarco Passport POS)
• Set one value less than the physical fueling position (Allied NexGen)
• Set to the physical fueling position (All other POS)

Step 13: Enter the CRIND ID and press ENTER

Step 14: Press CANCEL until you are back to the CRIND Config Menu

Step 15: Press 2 (CRIND Mode) and press ENTER

Step 16:            

• Press 1 (Gilbarco Passport POS) and press ENTER
• Press 2 (Any other POS) and press ENTER

Step 17: Press CANCEL until you are back to the CRIND Config Menu

Step 18: Press 3 (Generic Baud Rate)

• Serial set correct Baud Rate and press ENTER
• COIP set to IP and press ENTER

Step 19: Press CANCEL until you are back on the Main Menu

Step 20: Press 3 (Network Config Menu) and press ENTER

Step 21: Press 2 (Set IP Addresses) and press ENTER

Step 21: Program CRIND Side A IP, CRIND Side B IP, Netmask Address, and Gateway Address:

• CCP w/ SSOM

  • CRIND physical Side A

    1. Set CRIND Side A IP: 172.16.100.1

    2. Set CRIND Side B IP: 172.16.100.3

    5. Set Netmask Address: 255.255.255.0

    6. Set Gateway Address: 172.16.100.254

  • CRIND physical Side B

    1. Set CRIND Side A IP: 172.16.100.3

    2. Set CRIND Side B IP: 172.16.100.1

    5. Set Netmask Address: 255.255.255.0

    6. Set Gateway Address: 172.16.100.254

• CCP w/o SSOM 

  Call the Field Support Line Option 1

Step 22: Press CANCEL until you are back on the Network Config Menu

Step 23: Press 3 (Apply Network Settings)

Step 24: Press CANCEL until you get to the menu to EXIT